ISO 8873:1987Withdrawn

Cellular plastics, rigid — Spray-applied polyurethane foam for thermal insulation of buildings — Specification

Plastiques alvéolaires rigides — Mousse de polyuréthanne projetée utilisée dans l'isolation thermique des bâtiments — Spécifications

This edition has been replaced by ISO 8873-1:2006, ISO 8873-2:2007.

Abstract / scope

Specifies the rquirements and test methods for spray- applied rigid polyurethane cellular plastics used as thermal insulation in two loadbearing categories. The foam may be either produce on site or in a manufactoring facility. The test samples shall be representative of the in place finshed material and of sufficient quantity and size to allow the tests specified to be carried out. The property requirements of RC/PUR- SA for thermal insulation of buildings are listed in a table.

Life cycle

Replaced by

ISO/CD 8873Deleted (project abandoned)Cellular plastics, rigid — Spray-applied polyurethane foam for thermal insulation of buildings — SpecificationInternational Standard · ISO/TC 61/SC 10 ISO 8873-1:2006PublishedRigid cellular plastics — Spray-applied polyurethane foam for thermal insulation — Part 1: Material specificationsInternational Standard · Published 5 Dec 2006 · ISO/TC 61/SC 10 ISO 8873-2:2007PublishedRigid cellular plastics — Spray-applied polyurethane foam for thermal insulation — Part 2: ApplicationInternational Standard · Published 4 May 2007 · ISO/TC 61/SC 10 ISO 8873-3:2007WithdrawnRigid cellular plastics — Spray-applied polyurethane foam for thermal insulation — Part 3: Test methodsInternational Standard · Published 4 May 2007 · ISO/TC 61/SC 10