ISO 11414:1996Withdrawn

Plastics pipes and fittings — Preparation of polyethylene (PE) pipe/pipe or pipe/fitting test piece assemblies by butt fusion

Tubes et raccords en matières plastiques — Préparation d'éprouvettes par assemblage tube/tube ou tube/raccord en polyéthylène (PE) par soudage bout à bout

This edition has been replaced by ISO 11414:2009.

Abstract / scope

Describes a procedure for preparing butt-fusion-jointed test piece assemblies between polyethylene (PE) pipes and spigot-ended fittings. Specifies the assembly parameters such as ambient temperature, joint geometry and fusion parameters.

Life cycle

Replaced by

ISO/CD 11414Deleted (project abandoned)Plastics pipes and fittings — Preparation of polyethylene (PE) pipe/pipe or pipe/fitting test piece assemblies by butt fusionInternational Standard · ISO/TC 138/SC 5 ISO 11414:2009PublishedPlastics pipes and fittings — Preparation of polyethylene (PE) pipe/pipe or pipe/fitting test piece assemblies by butt fusionInternational Standard · Published 29 Jan 2009 · ISO/TC 138/SC 5