ISO 22:1991Published

Belt drives — Flat transmission belts and corresponding pulleys — Dimensions and tolerances

Transmissions par courroies — Courroies plates de transmission et poulies correspondantes — Dimensions et tolérances

Abstract / scope

Specifies the principal dimensions. Annexes A (recommended crowns of the pulleys) and B (recommended correspondence between the widths of belts and the widths of the pulleys used) are for information only.

Life cycle

Replaces

ISO 22:1975WithdrawnFlat transmission belts and corresponding pulleys — WidthsInternational Standard · Published 1 May 1975 · ISO/TC 41 ISO 63:1975WithdrawnFlat transmission belts — LengthsInternational Standard · Published 1 May 1975 · ISO/TC 41 ISO 99:1975WithdrawnPulleys for flat transmission belts — DiametersInternational Standard · Published 1 May 1975 · ISO/TC 41 ISO 100:1984WithdrawnPulleys for flat transmission belts — CrownsInternational Standard · Published 1 Apr 1984 · ISO/TC 41/SC 1

Replaced by

ISO/WD 22Deleted (project abandoned)Belt drives — Flat transmission belts and corresponding pulleys — Dimensions and tolerancesInternational Standard · ISO/TC 41/SC 1