+91 80984 42953 hello@sascert.in
Verify a certificate ISO standards library Download brochure
ISO 6336-1:2006Withdrawn

Calculation of load capacity of spur and helical gears — Part 1: Basic principles, introduction and general influence factors

Calcul de la capacité de charge des engrenages cylindriques à dentures droite et hélicoïdale — Partie 1: Principes de base, introduction et facteurs généraux d'influence

This edition has been replaced by ISO 6336-1:2019.

Abstract / scope

ISO 6336-1:2006 presents the basic principles of, an introduction to, and the general influence factors for, the calculation of the load capacity of spur and helical gears. Together with ISO 6336-2, ISO 6336-3, ISO 6336-5 and ISO 6336-6, it provides a method by which different gear designs can be compared. It is not intended to assure the performance of assembled drive gear systems. It is not intended for use by the general engineering public. Instead, it is intended for use by the experienced gear designer who is capable of selecting reasonable values for the factors in these formulae based on knowledge of similar designs and awareness of the effects of the items discussed.

The formulae in ISO 6336 are intended to establish a uniformly acceptable method for calculating the pitting resistance and bending strength capacity of cylindrical gears with straight or helical involute teeth.

Life cycle

Amendments & corrigenda

ISO 6336-1:2006/Cor 1:2008WithdrawnCalculation of load capacity of spur and helical gears — Part 1: Basic principles, introduction and general influence factors — Technical Corrigendum 1International Standard · Published 26 May 2008 · ISO/TC 60/SC 2

Replaces

ISO 6336-1:1996WithdrawnCalculation of load capacity of spur and helical gears — Part 1: Basic principles, introduction and general influence factorsInternational Standard · Published 9 May 1996 · ISO/TC 60/SC 2ISO 6336-1:1996/Cor 1:1998WithdrawnCalculation of load capacity of spur and helical gears — Part 1: Basic principles, introduction and general influence factors — Technical Corrigendum 1International Standard · Published 15 Oct 1998 · ISO/TC 60/SC 2ISO 6336-1:1996/Cor 2:1999WithdrawnCalculation of load capacity of spur and helical gears — Part 1: Basic principles, introduction and general influence factors — Technical Corrigendum 2International Standard · Published 9 Sep 1999 · ISO/TC 60/SC 2

Replaced by

ISO 6336-1:2019PublishedCalculation of load capacity of spur and helical gears — Part 1: Basic principles, introduction and general influence factorsInternational Standard · Published 27 Nov 2019 · ISO/TC 60/SC 2