ISO 6162-2:2002Withdrawn

Hydraulic fluid power — Flange connectors with split or one-piece flange clamps and metric or inch screws — Part 2: Flange connectors for use at pressures of 35 MPa (350 bar) to 40 MPa (400 bar), DN 13 to DN 51

Transmissions hydrauliques — Raccordements à bride avec demi-brides ou bride monobloc et vis métriques ou en inches — Partie 2: Raccordements à bride pour utilisation à des pressions de 35 MPa (350 bar) à 40 MPa (400 bar), DN 13 à DN 51

Abstract / scope

ISO 6162-2:2002 specifies complete general and dimensional characteristics for flange heads, split flange clamps (FCS), one-piece flange clamps (FC) and ports applicable to four-screw, split and one-piece flange clamp type tube and hose connectors for use at pressures of 35 MPa (350 bar) to 40 MPa (400 bar). It also specifies the dimensions of the seals to be used, as well as the grooves to house the seal.

ISO 6162-2:2002 also recognizes the need to accommodate metric screw fasteners, as well as to provide a means to use existing inch screw fasteners.

Life cycle

Replaces

ISO 6162:1994WithdrawnHydraulic fluid power — Four-screw split-flange connections for use at pressures of 2,5 MPa to 40 MPa (25 bar to 400 bar) — Type I metric series and type II inch seriesInternational Standard · Published 14 Apr 1994 · ISO/TC 131/SC 4

Replaced by

ISO 6162-2:2012WithdrawnHydraulic fluid power — Flange connections with split or one-piece flange clamps and metric or inch screws — Part 2: Flange connectors, ports and mounting surfaces for use at a pressure of 42 MPa (420 bar), DN 13 to DN 76International Standard · Published 14 Dec 2012 · ISO/TC 131/SC 4