ISO 3739-1:2007Withdrawn

Industrial tyres and rims — Part 1: Pneumatic tyres (metric series) on 5 degrees tapered or flat base rims — Designation, dimensions and marking

Pneumatiques et jantes industriels pour matériel de manutention — Partie 1: Pneumatiques (série millimétrique) montés sur jantes coniques à 5 degrés ou à base plate — Désignation, cotes et marquage

This edition has been replaced by ISO 3739-1:2022.

Abstract / scope

ISO 3739-1:2007 specifies the main requirements of the metric series of pneumatic tyres primarily intended for industrial vehicles, including designations, dimensions and markings. The tyres are based on the following parameters:

speeds not exceeding 50 km/h;
use on 5° tapered or flat base rims.

The conversion of code-designated industrial tyres into metric-designated tyres is outside the scope of ISO 3739-1:2007.

Life cycle

Replaces

ISO 3739-1:1992WithdrawnIndustrial tyres and rims — Part 1: Pneumatic tyres (metric series) on 5 degrees tapered or flat base rims — Designation, dimensions and markingInternational Standard · Published 7 May 1992 · ISO/TC 31/SC 7

Replaced by

ISO/DIS 3739-1Deleted (project abandoned)Industrial tyres and rims — Part 1: Pneumatic tyres (metric series) on 5 degrees tapered or flat base rims — Designation, dimensions and markingInternational Standard · ISO/TC 31/SC 7 ISO 3739-1:2022PublishedIndustrial tyres and rims — Part 1: Pneumatic tyres (metric series) on 5 degrees tapered or flat base rims — Designation, dimensions and markingInternational Standard · Published 11 Oct 2022 · ISO/TC 31/SC 7