ISO 10360-5:2010Withdrawn

Geometrical product specifications (GPS) — Acceptance and reverification tests for coordinate measuring machines (CMM) — Part 5: CMMs using single and multiple stylus contacting probing systems

Spécification géométrique des produits (GPS) — Essais de réception et de vérification périodique des machines à mesurer tridimensionnelles (MMT) — Partie 5: MMT utilisant des systèmes de palpage à stylet simple ou à stylets multiples

This edition has been replaced by ISO 10360-5:2020.

Abstract / scope

ISO 10360-5:2010 specifies acceptance and periodic reverification tests of CMM performance with contacting probing systems and is only applicable to CMMs using any type of contacting probing system, a discrete point probing mode, and spherical or hemispherical stylus tip(s).

It complements ISO 10360-7, which is the module for CMMs with video probing systems, and ISO 10360-2, which is universal, i.e. not probe-type specific.

ISO 10360-5:2010 applies to CMMs supplied with any of the following: single-stylus probing system; multi-stylus probing systems with fixed multiple styli attached to a single probe (e.g. “star” stylus); multiple probing systems such as those with a stylus for each of their probes; systems with articulating probing; stylus and probe changing systems; manual (non-driven) CMMs.

ISO 10360-5:2010 is not applicable to non-contacting probing systems, which require different testing procedures.

Life cycle

Replaces

ISO 10360-5:2000WithdrawnGeometrical Product Specifications (GPS) — Acceptance and reverification tests for coordinate measuring machines (CMM) — Part 5: CMMs using multiple-stylus probing systemsInternational Standard · Published 21 Dec 2000 · ISO/TC 213 ISO/PAS 12868:2009WithdrawnGeometrical product specification (GPS) — Coordinate measuring machines (CMM): Testing the performance of CMMs using single-stylus contacting probing systemsPublicly Available Specification · Published 27 Nov 2009 · ISO/TC 213

Replaced by

ISO 10360-5:2020PublishedGeometrical product specifications (GPS) — Acceptance and reverification tests for coordinate measuring systems (CMS) — Part 5: Coordinate measuring machines (CMMs) using single and multiple stylus contacting probing systems using discrete point and/or scanning measuring modeInternational Standard · Published 31 Mar 2020 · ISO/TC 213