ISO 286-1:1988Withdrawn

ISO system of limits and fits — Part 1: Bases of tolerances, deviations and fits

Système ISO de tolérances et d'ajustements — Partie 1: Base des tolérances, écarts et ajustements

This edition has been replaced by ISO 286-1:2010.

Abstract / scope

This part gives the bases of the ISO system of limits and fits together with the calculated values of the standard tolerances and fundamental deviations. It also gives terms and definitions together with associated symbols.

Life cycle

Replaces

ISO/R 286:1962WithdrawnISO system of limits and fits — Part I : General, tolerances and deviationsRecommendation · Published 1 Dec 1962 · ISO/TC 213

Replaced by

ISO/DIS 286-1Deleted (project abandoned)Geometrical product specifications (GPS) — ISO coding system for tolerances of linear sizes — Part 1: Bases of tolerances and fitsInternational Standard · ISO/TC 213 ISO 286-1:2010PublishedGeometrical product specifications (GPS) — ISO code system for tolerances on linear sizes — Part 1: Basis of tolerances, deviations and fitsInternational Standard · Published 16 Apr 2010 · ISO/TC 213