ISO 286-2:1988/DAmd 1Deleted (project abandoned)

ISO system of limits and fits — Part 2: Tables of standard tolerance grades and limit deviations for holes and shafts — Amendment 1

Système ISO de tolérances et d'ajustements — Partie 2: Tables des degrés de tolérance normalisés et des écarts limites des alésages et des arbres — Amendement 1

This edition has been replaced by ISO 286-2:2010.

Abstract / scope

No abstract published for this document yet.

Life cycle

Replaced by

ISO 286-2:2010PublishedGeometrical product specifications (GPS) — ISO code system for tolerances on linear sizes — Part 2: Tables of standard tolerance classes and limit deviations for holes and shaftsInternational Standard · Published 7 Jun 2010 · ISO/TC 213