ISO 3501:2015Withdrawn

Plastics piping systems — Mechanical joints between fittings and pressure pipes — Test method for resistance to pull-out under constant longitudinal force

Systèmes de canalisations en plastique — Assemblages mécaniques entre raccords et tubes sous pression — Méthode d'essai de résistance à l'arrachement sous une force longitudinale constante

This edition has been replaced by ISO 3501:2021.

Abstract / scope

ISO 3501:2015 specifies a method for checking the ability of assembled uniaxial joints between fittings and plastic pressure pipes to withstand longitudinal tensile stresses. The test applies regardless of the design and material of the fitting used for jointing plastics pipe. This test method is not applicable to fusion-welded joints.

Life cycle

Replaces

ISO 3501:1976WithdrawnAssembled joints between fittings and polyethylene (PE) pressure pipes — Test of resistance to pull outInternational Standard · Published 1 Jun 1976 · ISO/TC 138/SC 2

Replaced by

ISO 3501:2021PublishedPlastics piping systems — Mechanical joints between fittings and pressure pipes — Test method for resistance to pull-out under constant longitudinal forceInternational Standard · Published 14 Dec 2021 · ISO/TC 138/SC 5