ISO 9628:2019Published

Rolling bearings — Insert bearings and eccentric locking collars — Geometrical product specifications (GPS) and tolerance values

Roulements — Roulements insert et bagues de blocage excentriques — Spécification géométrique des produits (GPS) et valeurs de tolérances

A new edition is under development: ISO/AWI 25260-1.

Abstract / scope

This document specifies the dimensional and geometrical characteristics, boundary dimensions and tolerances of insert bearings and eccentric locking collars and the radial internal clearances of insert bearings.

Life cycle

Replaces

ISO 9628:2006WithdrawnRolling bearings — Insert bearings and eccentric locking collars — Boundary dimensions and tolerancesInternational Standard · Published 29 Mar 2006 · ISO/TC 4/SC 6 ISO 9628:2006/Amd 1:2011WithdrawnRolling bearings — Insert bearings and eccentric locking collars — Boundary dimensions and tolerances — Amendment 1: Diameter series 3International Standard · Published 23 Feb 2011 · ISO/TC 4/SC 6

Replaced by

ISO/AWI 25260-1Under developmentRolling bearings — Insert bearing units — Part 1: Geometrical product specifications (GPS) and tolerance values for insert bearings and eccentric locking collarsInternational Standard · ISO/TC 4/SC 6