ISO 2768-1:1989Published

General tolerances — Part 1: Tolerances for linear and angular dimensions without individual tolerance indications

Tolérances générales — Partie 1: Tolérances pour dimensions linéaires et angulaires non affectées de tolérances individuelles

A new edition is under development: ISO 2768.

Abstract / scope

This part is intended to simplify drawing indications and specifies general tolerances in four tolerance classes. It applies to the dimensions of workpieces that are produced by metal removal or are formed from sheet metal. It contains three tables and an informative annex with regard to concepts behind general tolerancing of dimensions.

Life cycle

Replaces

ISO 2768:1973WithdrawnPermissible machining variations in dimensions without tolerance indicationInternational Standard · Published 1 Dec 1973 · ISO/TC 213

Replaced by

ISO/PWI 2768-1Deleted (project abandoned)Geometrical product specifications (GPS) — General tolerances — Part 1: Tolerances for linear and angular dimensions without individual tolerance indicationsInternational Standard · ISO/TC 213 ISO 2768Under developmentGeometrical product specifications (GPS) — Dimensional tolerancing — Tolerance limits for general specification of linear and angular sizesInternational Standard · ISO/TC 213