ISO 12151-2:2022Published

Connections for hydraulic fluid power and general use — Hose fittings — Part 2: Hose fittings with ISO 8434-1 24° cone connector ends with O-rings

Raccordements pour transmissions hydrauliques et applications générales — Flexibles de raccordement — Partie 2: Flexibles avec embouts à cône à 24 degrés et joints toriques conformes à l'ISO 8434-1

Abstract / scope

This document specifies the general and dimensional requirements for the design and performance of hose fittings with 24° cone connector ends with O-rings according to ISO 8434‑1. These hose fittings are made of carbon steel and are intended for use with hoses with nominal inside diameters from 5 mm through 38 mm (inclusive).

NOTE For hose fittings used in hydraulic and pneumatic braking systems on road vehicles, see ISO 4038, ISO 4039‑1 and ISO 4039‑2.

These hose fittings are for use in hydraulic fluid power systems with hoses that meet the requirements of respective hose standards and in general applications with suitable hoses.

Life cycle

Replaces

ISO 12151-2:2003WithdrawnConnections for hydraulic fluid power and general use — Hose fittings — Part 2: Hose fittings with ISO 8434-1 and ISO 8434-4 24 degree cone connector ends with O-ringsInternational Standard · Published 20 May 2003 · ISO/TC 131/SC 4