ISO 3193:1991Withdrawn

Aerospace — Bolts, normal hexagonal head, normal shank, short or medium length MJ threads, metallic material, coated or uncoated, strength classes less than or equal to 1 100 MPa — Dimensions

Aéronautique et espace — Vis à tête hexagonale normale, avec tige normale et filetage MJ court ou de longueur moyenne, en matériau métallique, revêtues ou non revêtues, des classes de résistance inférieures ou égales à 1 100 MPa — Dimensions

This edition has been replaced by ISO 3193:2008.

Abstract / scope

Specifies the dimensions of these bolts. Is intended for the drawing-up of aerospace product standards. Dimensions and tolerances are given in figure 1 and table 1. They are applicable after any surface coating, but before the application of any lubricant. Details of form not stated are left to the manufacturer's discretion.

Life cycle

Amendments & corrigenda

ISO 3193:1991/Cor 1:1992WithdrawnAerospace — Bolts, normal hexagonal head, normal shank, short or medium length MJ threads, metallic material, coated or uncoated, strength classes less than or equal to 1 100 MPa — Dimensions — Technical Corrigendum 1International Standard · Published 6 Feb 1992 · ISO/TC 20/SC 4

Replaced by

ISO/WD 3193Deleted (project abandoned)Aerospace — Bolts, normal hexagonal head, normal shank, short or medium length MJ threads, metallic material, coated or uncoated, strength classes less than or equal to 1 100 MPa — DimensionsInternational Standard · ISO/TC 20/SC 4 ISO 3193:2008PublishedAerospace — Bolts, normal hexagonal head, normal shank, short or medium length MJ threads, metallic material, coated or uncoated, strength classes less than or equal to 1 100 MPa — DimensionsInternational Standard · Published 18 Aug 2008 · ISO/TC 20/SC 4