ISO 5414-2:1982Withdrawn

Tool chucks (end mill holders) with clamp screws for flatted parallel shank tools — Part 2: Connecting dimensions of chucks

Mandrins porte-outils, à vis de blocage, pour outils à queue cylindrique à méplat — Partie 2: Dimensions d'encombrement des mandrins

This edition has been replaced by ISO 5414-2:2002.

Abstract / scope

ISO 5414-2 specifies the dimensions of two types of connection: chucks with 7/24 taper shanks for tool shanks with either single flat or a double flat and chucks with Morse taper shanks for tool shanks with a single flat only. Morse tapers shall conform with ISO 296 and ISO 5413 and 7/24 tapers shall conform with ISO 297 and ISO 2583. Flatted parallel shanks installed in these chucks shall conform to ISO 3338-2.

Life cycle

Replaced by

ISO 5414-2:2002PublishedTool chucks (end mill holders) with clamp screws for flatted cylindrical shank tools — Part 2: Connecting dimensions of chucks and designationInternational Standard · Published 25 Oct 2002 · ISO/TC 29/SC 9