+91 80984 42953 hello@sascert.in
Verify a certificate ISO standards library Download brochure
ISO 5414-1:2002Published

Tool chucks (end mill holders) with clamp screws for flatted cylindrical shank tools — Part 1: Dimensions of the driving system of tool shanks

Mandrins porte-outils, à vis de blocage, pour outils à queue cylindrique à méplat — Partie 1: Dimensions du système d'entraînement des queues d'outils

Abstract / scope

ISO 5414-1 lays down the dimensions of tool chucks (end mill holders) with clamp screws designed for driving flatted cylindrical shanks in accordance with ISO 3338-2 and specifies the clamp screws used. It also gives the maximum diameter of the chuck nose.

ISO 5414-1 defines two types of drive:

chucks with bores equal to or less than 20 mm intended for driving cylindrical shank tools with a single flat, these tools being provided with either a single or a double cutting part; chucks with bores equal to or more than 25 mm intended for driving cylindrical shank tools with a double flat, these tools being provided with a single cutting part only.

Life cycle

Replaces

ISO 5414-1:1985/DAmd 1Deleted (project abandoned)Tool chucks (end mill holders) with clamp screws for flatted parallel shank tools — Part 1: Dimensions of the driving system of tool shanks — Amendment 1: Shanks with diameter 14 mm and 18 mm and adding of dimensions l4International Standard · ISO/TC 29ISO 5414-1:1985WithdrawnTool chucks (end mill holders) with clamp screws for flatted parallel shank tools — Part 1: Dimensions of the driving system of tool shanksInternational Standard · Published 7 Nov 1985 · ISO/TC 29

Replaced by

ISO/NP 5414-1Deleted (project abandoned)Tool chucks (end mill holders) with clamp screws for flatted cylindrical shank tools — Part 1: Dimensions of the driving system of tool shanksInternational Standard · ISO/TC 29